Follow These 11 Pro Tips to Carve the Perfect Pumpkin

The cinnamon trick is pure genius.

Come Halloween, most of us bust out our art skills (no matter how novice) and try to create our own pumpkin masterpiece. And it's not easy. These expert carving tips will have your gourds looking and smelling good the entire trick-or-treating season. If you're still in need of some inspiration, take a look at our best pumpkin carving ideas.

1. Good carving starts with the right pumpkin.

Choose one that's fresh, with a sturdy stem, no bruises, and a flat bottom so it won't roll while you carve.

2. Try cutting from the bottom, instead of the top.

Michael Natiello, pumpkin carving pro and creative director for , says cutting your "lid" from the bottom of the pumpkin helps prevent the sides from caving in later.

3. If you do carve from the top, cut out the lid on an angle.

This way it won't drop inside the pumpkin when you replace it, like it would with a straight up-and-down cut. A should work well for this.

4. Scoop out all the pulp — and then some.

You can buy a for pumpkin gutting, but an will do just fine. Thin the inner wall of the "face" area to 1¼-inch thick, so it will be easier to pierce the shell.

5. Sketch out your design on paper first.

If you draw your jack-o'-lantern face to size, Natiello says you can use it as a pattern: Just tape it to the front of your pumpkin and use a fork or pencil to poke holes along the lines you want to carve. (Or save yourself from creative blocks by getting a , complete with a marker, scraper, cutting tools, and pre-made patterns.)

6. Try holding the pumpkin in your lap.

It's easier to create features when the face is gazing up at you. Natiello suggests using a serrated kitchen knife or an X-Acto knife for carving, but to make intricate designs, you could try using a small saw. Just don't cut on a slant — clean up-and-down slices look best.

7. Start by making simple rough cuts.

If you get the big pieces of pumpkin out of the way first, you can go back and clean up the edges of your design later.

8. Use your scraps creatively.

Make a tongue, pipe, or hair accessories out of a discarded piece of pumpkin shell, for example.

9. Keep your pumpkin fresh.

Natiello recommends spreading petroleum jelly on the cut edges to seal in moisture. If your pumpkin still shrivels a few days later, you can revive it with a facedown soak in cold water for up to eight hours.

10. Create a chimney.

First, leave the lid on for a few minutes while burns. Then make a small hole where the lid has blackened. Or, save yourself the stress and go with instead.

11. Sprinkle a little cinnamon inside the lid.

That way, when you light the candle, your jack-o'-lantern will smell like a pumpkin pie. Yum.

Advertisement - Continue Reading Below